Facade Reinforcement

Facade Reinforcement

Flügger Facade is products for exterior treatment of mineral substrates. Provides a diffusion-open, weather-resistant surface.

Product Description

Pigmented structural primer which which evens out minor irregularities in the substrate. Reinforces minor cracking, such as shrinkage, cracking or settlement cracking.
  • Reinforces cracks
  • Fine-grained structure
  • Evens out minor irregularities


Intermediate treatment of mineral facades before final treatment using facade paint.


Must be primed or previously treated, clean, dry, firm and suitable for surface treatment.


Remove loose paint and plaster by cleaning.
Dirt, grease and chalking material should be removed using Façade Clean.
Algae, mould and mould growth are removed by cleaning with Façade Algae Remover.
Fill larger cracks with the same material.
Prime new, light chalking or absorbent substrates using Flügger Facade Primer.
For finish treatment, use Flügger Facade Universal or Flügger Facade Beton paint.


Brush or roller.
Decide on your mode of application according to the desired finish.
Apply wet on wet, finish by brushing or rolling in the same direction.
If scratches and cracks are not filled after one application, repeat the treatment.
Filling and reinforcing ability is boosted by applying thicker layers.
Cold / heat can affect the viscosity of the material
Avoid condensation forming.
Avoid working in direct sunlight and on hot surfaces.
Cold and increased humidity extends drying time, full curing and recoat interval.
Increased temperature and low atmospheric humidity reduce drying time and full curing.
Always test adhesion and result before hanging.


Matt, covered surface with fine grained structure.
Reinforcing effect is boosted by applying thicker layers.

Be Aware

Protect freshly painted surface from adverse weather conditions.
Take appropriate measures against the effects of moisture and rainfall on freshly painted surfaces.
The surface achieves maximum robustness when fully cured.

Environmental information

Clean off the paint from tools and wash them with water. Bring remains of fluent paint to the local recycling centre. Minimize your paint waste by pre-estimating how much paint you need. Keep the leftover paint for future use so you can effectively reduce the environmental impact.

Storage: Cool, frost free and tightly closed

Protection equipment: Painting: eye protection, gloves. Sanding: respiratory protection.

Technical Data

Priming paint
Density (kg/liter)
Weight %
Volume %
Nominal spreading rate (m2/l)
Workable temperature
Min. +5°C
Max. humidity 80 % RH.
Dry to touch at 20°C, 60% RF (Hours)
Fully cured at 20c, 60% RF (Days)
EN Tæthed
Water vapour: Sd = 0.30 m corresponding to class 2 according to EN 7783-2
Cleaning of Tools etc.

Current TDS Version

juni 2021

Replaces TDS Version

juni 2021