Metal Pro Sheet Paint

Metal Pro Sheet Paint

Product Description

Flügger Sheet Metal Paint provides an extraordinarily weather-resistant surface, which is very colour and gloss fast. Provides a dirt-repellent and hard surface. Hampers formation of mould on the surface. Fine application qualities. Registered in the Nordic Ecolabelling Building Products Database for products which can be used in buildings with the Swan label.

Treatment

The substrate must be clean, dry and solid, free from dirt, grease and oil.
Clean off loose paint until clean substrate. Remove rust, if any, by steel
brush or by sanding or sand-blasting. Clean with Flügger Metal Pro Cleaner.
Remove mould, if any, with Flügger Façade Anti-green.
After application of the cleaning agents, it is important to rinse abundantly
with clean water. Flat sand glossy or painted surfaces.
Prime untreated and bare metal. Prime areas of bare iron with Flügger
Anti-corrosive Primer, prime bare zinc with Flügger Multi Primer. Always
perform a test on the substrate before treatment in order to
verify if the adhesion is satisfactory. Please refer to Flügger Application
Guide for further instructions. Apply by paint brush, by paint roller or by
spraying. Do not apply in direct sun. Apply 2 coats of primer and 2 topcoats
for the best result.

Application

Flügger Sheet Metal Paint has been developed specially for painting
pre-lacquered steel, rust-protected, zinc-coated and plastisol coated steel
and aluminium. Suitable for exterior use on facades and roofs of sheet metal
on e.g. residential housings, industrial buildings, agricultural holdings,
stables, warehouses, etc.

Be Aware

A roof with a slope of less than 15°C is not suitable for paint treatment.
Protect freshly painted surface from adverse weather conditions.
Take appropriate measures against the effects of moisture and rainfall on freshly painted surfaces.
The surface achieves maximum robustness when fully cured.

Storage: Cool, frost-free and tightly closedKey: METALPLADE February 2011, replaces September 2009

Technical Data

Producttype
Acrylic paint
Gloss
30, Semi Gloss
Density (kg/liter)
1.2
Weight %
51
Volume %
37
Nominal spreading rate (m2/l)
8
Workable temperature
Min. +10°C
Dry to touch at 20°C, 60% RF (Hours)
1
Fully cured at 20c, 60% RF (Days)
28
Dilution
Not to be diluted
Cleaning of Tools etc.
Water
Supplementary Info
Registered in the Nordic Ecolabelling Building Products Database for products which can be used in buildings with the Swan label.

Current TDS Version

august 2020


Replaces TDS Version

januar 2020